How to Use Magewell 4K Capture Device to Capture at 2560x1440p144

When do you need to capture at 2560x1440p144?

Some monitors have a resolution and refresh rate of 2560x1440p 144Hz. Gamers of those monitors might need to stream or record games at 2560x1440p 144 fps.

What do you need to capture this signal?

Pro Capture HDMI 4K Plus

Pro Capture AIO 4K Plus

USB Capture HDMI 4K Plus

Pro Capture HDMI 4K Plus LT

*Please note that due to the limit of USB 3.0 bandwidth, the frame rate of the captured video cannot reach 144 fps.

How to capture?

Solution 1:

Hardware requirement: The computer graphics card can simultaneously output at least two HDMI signals.

Steps:

1. Physical connection: Connect the capture device with the streaming/recording computer and make sure the device works. Connect the output of the graphics card to the capture device and monitor respectively.

2. Set the display:

Open the graphics card control panel and set the resolution at 2560x1440 and the refresh rate at 144 Hz.

The display mode of the two screens should be set to “duplicate”.

3. Configure the capture device:

If a capture card is used: Open the capture card control panel in streaming/recording software such as Amcap and Capture Express and then select “HDMI” tab. In the “EDID” part, click “Load” to load the EDID prepared by Magewell.

If a USB capture device is used: Run USB Capture Utility V3 and click “HDMI” tab. In the “EDID” part, untick “SmartEDID” to disable it.

Click “Import” to load the EDID file prepared by Magewell.

4. Now the device can capture properly.

Solution 2:

Hardware limitation:The computer graphics card can output only one HDMI signal. Only Pro Capture HDMI 4K Plus LT and USB Capture HDMI 4K Plus can be used for this solution.

Steps:

1. Physical connection: Connect the output of the graphics card to the input of the capture device using a HDMI cable. Connect the loop-through of the capture device to the monitor using a HDMI cable.

2. Set the display:

Set the display: Open the graphics card control panel and set the resolution at 2560x1440 and the refresh rate at 144 Hz.

3. Configure the capture device:

Run USB Capture Utility V3 and click “HDMI” tab. In the “EDID” part, untick the “SmartEDID” to disable it.

Click “Import” to load the EDID file prepared by Magewell.

4. Now the device can capture properly.

If you have more questions about this tutorial, please contact [email protected]

江苏七位数开奖 大发快三是不是正规的 广东11选五走势图一定牛 黑龙江p62 河南福彩快三开奖结果 策略论坛 河南快3和值走势图一定牛 北京11选五走势图一 好彩1预测 加拿大28害了多少人 期货开户哪个公司好